Rear Wiper Arm

Removal

1. Remove wiper arm cover, and remove rear wiper arm nut.
2. Remove the wiper arm.
3. Remove wiper blade from the wiper arm.
   Fig 1: Removing Wiper Arm Cover

   Courtesy of NISSAN NORTH AMERICA, INC.

Installation

1. Operate rear wiper motor one full cycle, then turn "OFF" (Auto Stop).
2. Clean pivot area as shown in illustration below. This will reduce the possibility of wiper arm looseness.
   Fig 2: Cleaning Pivot Area

   Courtesy of NISSAN NORTH AMERICA, INC.
3. Install wiper blade on the wiper arm.
4. Install wiper arm so that the arm rests in the stopper and tighten rear wiper arm nut.
5. Install wiper arm cover.