Rear Window Stay Disposal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Fix window stay (1) using a vise (C).
Using hacksaw (A) slowly make two holes in the window stay, in numerical order as shown in the figure.
CAUTION:
- When cutting a hole on window stay, always cover a hacksaw using a shop cloth (B) to avoid scattering metal fragments or oil.
- Wear eye protection (safety glasses).
- Wear gloves.
  
  Fig 1: Making Holes In Rear Window Stay Using Hacksaw
  Courtesy of NISSAN NORTH AMERICA, INC.
1. 20 mm (0.787 in)
2. Cut in numerical order as shown at the groove.
  
  Fig 2: Identifying Numerical Order For Cutting Groove
  Courtesy of NISSAN NORTH AMERICA, INC.