Diagnosis Procedure

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

CHECK PEDAL ADJUSTING MOTOR POWER SUPPLY

Turn the ignition switch OFF.
Perform "Active test" ("PEDAL MOTOR") with CONSULT.

Check voltage between automatic drive positioner control unit harness connector and ground.

Terminal			Test Item		Voltage (V) (Approx.)
(+)		(-)
Automatic drive positioner control unit connector	Terminal	(-)
M34	37	Ground	PEDAL MOTOR	OFF	0
				RR (backward)	0
				FR (forward)	Battery voltage
	45			OFF	0
				RR (backward)	Battery voltage
				FR (forward)	0

Fig 1: Checking Voltage Between Automatic Drive Positioner Control Unit Connector M34 Terminals And Ground

Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES: Replace pedal adjusting motor assembly. Refer to "REMOVAL AND INSTALLATION ".

NO: GO TO 2

CHECK PEDAL ADJUSTING MOTOR CIRCUIT

Disconnect automatic drive positioner control unit and pedal adjusting motor assembly.

Check continuity between automatic drive positioner control unit harness connector and pedal adjusting motor harness connector.

Automatic drive positioner control unit connector	Terminal	Pedal adjusting motor assembly connector	Terminal	Continuity
M34 (A)	37	E109 (B)	2	Yes
M34 (A)	45	E109 (B)	1	Yes

Check continuity between automatic drive positioner control unit harness connector and ground.

Automatic drive positioner control unit connector	Terminal	Ground	Continuity
M34 (A)	37		No
	45

Fig 2: Checking Continuity Between Automatic Drive Positioner Control Unit Harness Connector M34 And Pedal Adjusting Motor Harness Connector E109 Terminals

Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES: GO TO 3

NO: Repair or replace harness.

CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".

Is the inspection result normal?

YES: Replace automatic drive positioner control unit. Refer to "REMOVAL AND INSTALLATION ".

NO: Repair or replace the malfunctioning part.