MIRROR SWITCH: Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK MIRROR SWITCH FUNCTION
   1. Turn ignition switch ON.
   2. Check voltage between automatic drive positioner control unit connector and ground.
      Fig 1: Checking Voltage Between Automatic Drive Positioner Control Unit Connector M33 And Ground

      Courtesy of NISSAN NORTH AMERICA, INC.

      Terminals			Mirror switch Condition	Voltage (V) (Approx.)
      (+)		(-)
      Automatic drive positioner control unit connector	Terminal
      M33	3	Ground	UP	0
      			Other than above	5
      	4		LEFT	0
      			Other than above	5
      	19		DOWN	0
      			Other than above	5
      	20		RIGHT	0
      			Other than above	5

      Is the inspection result normal? 

      YES: GO TO  6

      NO: GO TO 2

2. CHECK HARNESS CONTINUITY
   1. Turn ignition switch OFF.
   2. Disconnect automatic drive positioner control unit and door mirror remote control switch.
   3. Check continuity between automatic drive positioner control unit connector and door mirror remote control switch connector.

      Automatic drive positioner control unit connector	Terminal	Door mirror remote control switch connector	Terminal	Continuity
      M33	3	M163	6	Yes
      	4		5
      	19		14
      	20		4

   4. Check continuity between automatic drive positioner control unit connector and ground.
      Fig 2: Checking Continuity Between Automatic Drive Positioner Control Unit Connector M33 And Door Mirror Remote Control Switch Connector M163

      Courtesy of NISSAN NORTH AMERICA, INC.

      Automatic drive positioner control unit connector	Terminal	Ground	Continuity
      M33	3		No
      	4
      	19
      	20

      Is the inspection result normal? 

      YES: GO TO 3

      NO: Repair or replace harness.

3. CHECK DOOR MIRROR REMOTE CONTROL SWITCH GROUND CIRCUIT

   Check continuity between door mirror remote control switch connector and ground.

   Door mirror remote control switch connector	Terminal	Ground	Continuity
   M163	13		Yes

   Fig 3: Checking Continuity Between Door Mirror Remote Control Switch Connector M163 Terminal 13 And Ground

   Courtesy of NISSAN NORTH AMERICA, INC.

   Is the inspection result normal? 

   YES: GO TO 4

   NO: Repair or replace harness.

4. CHECK AUTOMATIC DRIVE POSITIONER CONTROL UNIT OUTPUT SIGNAL
   1. Connect automatic drive positioner control unit.
   2. Turn ignition switch ON.
   3. Check voltage between automatic drive positioner control unit and ground.

      Terminals			Voltage (V) (Approx.)
      (+)		(-)
      Automatic drive positioner control unit connector	Terminal
      M33	3	Ground	5
      	4
      	19
      	20

      Fig 4: Checking Voltage Between Automatic Drive Positioner Control Unit Connector M33 And Ground

      Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: GO TO 5

      NO: Replace automatic drive positioner control unit. Refer to "REMOVAL AND INSTALLATION ".

5. CHECK MIRROR SWITCH

   Check mirror switch.

   Refer to "MIRROR SWITCH: COMPONENT INSPECTION ".

   Is the inspection result normal? 

   YES: Refer to "INTERMITTENT INCIDENT ".

   NO: Replace door mirror remote control switch. Refer to "REMOVAL AND INSTALLATION ".

6. CHECK INTERMITTENT INCIDENT

   Check intermittent incident.

   Refer to "INTERMITTENT INCIDENT ".

   Is the inspection result normal? 

   YES: Replace automatic drive positioner control unit. Refer to "REMOVAL AND INSTALLATION ".

   NO: Repair or replace the malfunctioning parts.