Removal Of Seat Belt Retractor
WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Before servicing SRS, turn the ignition switch off, disconnect both battery terminals and wait at least three minutes.
- Disconnect the negative and positive battery terminals, then wait at least three minutes.
- Remove the center pillar upper and lower finishers. Refer to "REMOVAL AND INSTALLATION ".
- Remove anchor cover and seat belt lower anchor bolt.
- Remove the retractor anchor bolt, retractor bolt upper, then remove the retractor and belt assembly.
- On RH side, disconnect the seat belt tension sensor.
- Disconnect the seat belt pre-tensioner harness connector.
CAUTION:
- For installing/removing seat belt pre-tensioner connector, insert a thin screwdriver wrapped in tape into the notch, lift the lock and remove the connector.
- Install the connector with the lock raised, and push the lock into the connector.