Shock Absorber: Disposal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Set shock absorber horizontally with the piston rod fully extended.
Drill 2 - 3 mm (0.08 - 0.12 in) hole at the position (•) from top as shown in the figure to release gas gradually.
CAUTION:
- Wear eye protection (safety glasses).
- Wear gloves.
- Be careful with metal chips or oil blown out by the compressed gas.
NOTE:
- Drill vertically in this direction (<=).
- Directly to the outer tube avoiding brackets.
- The gas is clear, colorless, odorless, and harmless.
A: 20 - 30 mm (0.79 - 1.18 in)

Fig 1: Locating Position For Drilling Hole On Shock Absorber
Courtesy of NISSAN NORTH AMERICA, INC.
Position the drilled hole downward and drain oil by moving the piston rod several times.
CAUTION: Dispose of drained oil according to the law and local regulations.