Wheel Alignment Inspection: Toe-In

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Measure the toe-in of the rear wheels. If toe-in is out of specification, inspect and replace any damaged or worn rear suspension parts before adjusting.
Total toe-in: Refer to "WHEEL ALIGNMENT (UNLADEN*) ".
Adjust toe-in by turning adjusting bolt on rear lower link.
NOTE: Toe changes about 1.5 mm (0.059 in) [One side] with each graduation of the adjusting bolt.
Tighten the adjusting bolt nut to the specified torque.
Adjusting bolt nut: Refer to "COMPONENT ".

Fig 1: Identifying Adjusting Bolt And Rear Lower Link
Courtesy of NISSAN NORTH AMERICA, INC.