Removal and Installation: Installation

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Do not reuse the drive shaft inside flange bolts and washers, discard after removal and use new bolts and washers for installation.
Do not reuse the cotter pin, discard after removal and use a new cotter pin for installation.
Apply Genuine NISSAN grease or equivalent to contact surface between wheel hub and drive shaft. Refer to "FOR USA AND CANADA: FLUIDS AND LUBRICANTS " (United States and Canada), "FOR MEXICO: FLUIDS AND LUBRICANTS " (Mexico).
Tighten wheel nut to specification. Refer to "ADJUSTMENT ".