LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2256 (Transfer Case (TX15B)) >> Unit Removal And Installation >> Transfer Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Switch 4WD shift switch to 2WD and set transfer assembly to 2WD.
  2. Remove the under covers using power tool.
  3. Partially drain the transfer fluid. Refer to "REPLACEMENT ".
  4. Remove the center exhaust tube and main muffler. Refer to "REMOVAL AND INSTALLATION ".
  5. Remove the front and rear propeller shafts. Refer to "UNIT REMOVAL AND INSTALLATION " (front), "UNIT REMOVAL AND INSTALLATION " (rear).
    CAUTION: Do not damage spline, sleeve yoke and rear oil seal when removing rear propeller shaft.
  6. Remove the A/T nuts from the A/T crossmember. Refer to "4WD: EXPLODED VIEW ".
  7. Position two suitable jacks under the A/T and transfer assembly.
  8. Remove the A/T crossmember. Refer to "4WD: EXPLODED VIEW ".
    WARNING: Support A/T and transfer assembly using two suitable jacks while removing A/T crossmember.
  9. Disconnect the electrical connectors from the following:
    • ATP switch
    • 4LO switch
    • Wait detection switch
    • Transfer control device
  10. Disconnect each air breather hose from the following. Refer to "4WD: REMOVAL AND INSTALLATION ".
    • Transfer control device
    • Breather tube (transfer)
  11. Remove the transfer to A/T and A/T to transfer bolts.
  12. Remove the transfer assembly.
    WARNING: Support transfer assembly with suitable jack while removing it.
    CAUTION: Do not damage rear oil seal (A/T).
scientia non olet · About LEMON Manuals