LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2256 (Transfer Case (TX15B)) >> Removal And Installation >> Transfer Control Unit >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Switch 4WD shift switch to 2WD and set transfer assembly to 2WD.
    CAUTION: When removing transfer control unit, transfer state must be at 2WD.
  2. Turn the ignition switch OFF and disconnect negative battery terminal. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove the instrument lower panel LH. Refer to "REMOVAL AND INSTALLATION ".
  4. Disconnect the two transfer control unit connectors.
  5. Remove the transfer control unit bolts.
  6. Remove the transfer control unit.
    Fig 1: Identifying Transfer Control Unit
    G04898489Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals