Method For Adjustment With 4WD Shift Switch At "2WD"
WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
Select Adjustment Pattern
- Start engine. Run engine for at least 10 seconds.
- Check 4WD shift indicator lamp and 4LO indicator lamp.
Indicator lamp condition Refer procedure When 4WD shift indicator lamp or 4LO indicator lamp is flashing. "Pattern A" Except for above. "Pattern B"
Pattern A
- Stop vehicle and move A/T shift selector to "N" position with brake pedal depressed. Stay in "N" for at least 2 seconds.
- Turn 4WD shift switch to "4LO" position. Stay in "4LO" for at least 2 seconds.
- Turn ignition switch "OFF".
- Start engine.
- Erase self-diagnosis. Refer to "CONSULT FUNCTION (ALL MODE AWD/4WD) ".
- Check 4WD shift indicator lamp and 4LO indicator lamp again. Refer to "CHECK 4WD SHIFT INDICATOR PATTERN ".
If 4WD shift indicator lamp and 4LO indicator lamp do not indicate proper pattern, install new transfer control unit and retry the above check.
Pattern B
- Stop vehicle and move A/T shift selector to "N" position with brake pedal depressed. Stay in "N" for at least 2 seconds.
- Turn ignition switch "OFF".
- Start engine.
- Erase self-diagnosis. Refer to "CONSULT FUNCTION (ALL MODE AWD/4WD) ".
- Check 4WD shift indicator lamp and 4LO indicator lamp again. Refer to "CHECK 4WD SHIFT INDICATOR PATTERN ".
If 4WD shift indicator lamp and 4LO indicator lamp do not indicate proper pattern, install new transfer control unit and retry the above check.