Removal and Installation: Installation
WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal.
- After installation, check for vibration by driving the vehicle. Refer to "NVH TROUBLESHOOTING CHART ".
- If propeller shaft assembly of final drive assembly has been replaced, connect them as follows:
- Face companion flange mark (A) of the final drive (1) upward. With the mark (A) faced upward, couple the propeller shaft and the final drive so that the matching mark (B) of the propeller shaft (2) can be positioned as close as possible with the matching mark (C) of the final drive companion flange.
- Tighten propeller shaft and final drive bolts and nuts of the to specification. Refer to "REMOVAL AND INSTALLATION ".
CAUTION:
Do not reuse the bolts and nuts. Always install new ones.