EVAP Canister Vent Control Valve

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Removal

Remove left rear tire and wheel. Refer to "ADJUSTMENT ".
Remove left rear fender protector. Refer to "REMOVAL AND INSTALLATION OF REAR FENDER PROTECTOR ".
Disconnect the EVAP control pressure sensor connector.
Disconnect the EVAP canister purge hose.
Remove the EVAP canister retaining bolt.
Disconnect the fuel tank EVAP breather hose.
Disconnect the EVAP vent control valve connector.
Disconnect the EVAP vent control valve hose.
Reposition the EVAP canister.
Turn EVAP canister vent control valve counterclockwise.
Remove the EVAP canister vent control valve and O-ring.

Fig 1: Identifying Locked/Unlocked Position Of EVAP Canister Vent Control Valve
Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: Do not reuse O-ring.

Installation

Installation is in the reverse order of removal.

CAUTION: Do not reuse O-ring.