Self Diagnostic Result

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Operation Procedure

Connect CONSULT.
With engine at idle, touch SELF-DIAG RESULTS.
Display shows malfunction experienced since the last erasing operation.

NOTE: The details for TIME are as follows:

0: Error currently detected with transfer control unit.
Except for 0: Error detected in the past and memorized with transfer control unit.

Detects frequency of driving after DTC occurs (frequency of turning ignition switch ON/OFF).

How to Erase Self-diagnostic Results

Perform applicable inspection of malfunctioning item and then repair or replace.
Start engine and select SELF-DIAG RESULTS mode for ALL MODE AWD/4WD with CONSULT.
Touch ERASE on CONSULT screen to erase DTC memory.
CAUTION: If memory cannot be erased, perform applicable diagnosis.