Removal and Installation: Removal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Remove the wheel and tire using power tool.
Support the lower link using a suitable jack.
For the LH side only, remove the pinch bolt from the lower joint shaft at the steering gear, and position the lower joint shaft out of the way.
CAUTION:
- Do not damage the lower joint.
Fig 1: Locating Pinch Bolt Of Lower Joint Shaft
Courtesy of NISSAN NORTH AMERICA, INC.
Remove cotter pin and nut from upper link ball joint.
Separate upper link ball joint stud from steering knuckle using Tool.
Tool number: ST29020001 (J-24319-01)

Fig 2: Removing Cotter Pin And Nut From Upper Link Ball Joint
Courtesy of NISSAN NORTH AMERICA, INC.
Remove upper link bolts and nuts.

Fig 3: Locating Upper Link Bolts And Nuts
Courtesy of NISSAN NORTH AMERICA, INC.