Removal and Installation: Installation
WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal.
- For 4WD models, refer to
"VQ40DE: REMOVAL AND INSTALLATION
" (VQ40DE) and
"VK56DE: REMOVAL AND INSTALLATION
" (VK56DE) for drive shaft lock nut tightening torque.CAUTION: Always replace drive shaft lock nut and cotter pin.
- Refer to "DISASSEMBLY AND ASSEMBLY " for outer socket nut tightening torque.
- Refer to "COMPONENT " for front suspension tightening torques.
- When installing disc rotor on wheel hub and bearing assembly, align the marks.NOTE: When not using the alignment mark, refer to "REMOVAL AND INSTALLATION OF BRAKE CALIPER AND DISC ROTOR ".
- When installing wheel and tire, refer to "ADJUSTMENT ".
- Perform wheel alignment. Refer to "FRONT WHEEL ALIGNMENT ".