Swinging Force

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before checking the axial forces and end play, turn the lower ball joint at least 10 revolutions so that the ball joint is properly broken in.

Measure the ball joint swinging force using a suitable tool.
- Measure at the cotter pin hole for upper ball joint as shown in illustration below.
- Measure at the groove for lower ball joint as shown in illustration below.
  
  Fig 1: Identifying Cotter Pin Hole And Groove Of Upper And Lower Ball Joint
  Courtesy of NISSAN NORTH AMERICA, INC.
Verify the ball joint swinging force is within specification.
Swinging force (A)

(Measurement point at either cotter pin hole or groove of ball stud)

Upper: Refer to "BALL JOINT ".

Lower: Refer to "BALL JOINT ".

Fig 2: Checking Swinging Force Of Ball Joint
Courtesy of NISSAN NORTH AMERICA, INC.