LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2226 (Automatic Transmission) >> DTC/Circuit Diagnosis >> Closed Throttle Position And Wide Open Throttle Position Circuit >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK CAN COMMUNICATION LINE

    Perform the self-diagnosis. Refer to "CONSULT FUNCTION (TRANSMISSION) ".

    Is a malfunction in the CAN communication indicated in the results? 

    YES: Check CAN communication line. Refer to U1000 CAN COMM CIRCUIT .

    NO: GO TO 2.

  2. CHECK THROTTLE POSITION SIGNAL CIRCUIT

    With CONSULT 

    1. Turn ignition switch "ON". (Do not start engine.)
    2. Select "ECU INPUT SIGNALS" in "DATA MONITOR" mode for "TRANSMISSION" with CONSULT.
    3. Depress accelerator pedal and read out the value of "CLSD THL POS" and "W/O THL POS".

      OK or NG 

      OK: INSPECTION END 

      NG: Check the following. If NG, repair or replace damaged parts.

      • Perform the self-diagnosis for "ENGINE" with CONSULT.
      • Open circuit or short to ground or short to power in harness or connectors.
      • Pin terminals for damage or loose connection with harness connector.
scientia non olet · About LEMON Manuals