Id Registration Without Transmitter Activation Tool
WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This procedure must be done after replacement of a TPMS transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 or Signal Tech II Tool J-50190 before ID registration can be performed.
- Connect CONSULT.
- Select ID REGIST under BCM.
- Adjust the tire pressures to the values shown in the table and drive the vehicle at 40 km/h (25 MPH) or more for a few minutes.
Tire position Tire pressure kPa (kg/cm2 , psi) Front LH 250 (2.5, 36) Front RH 230 (2.3, 33) Rear RH 210 (2.1, 30) Rear LH 190 (1.9, 27) - After completing all ID registrations, press END to complete the procedure.
Activation tire position CONSULT Front LH YET
↓
DONEFront RH Rear RH Rear LH - Inflate all tires to proper pressure. Refer to "TIRE ".