Intake Valve Timing Control Position Sensor (Bank 2) (RH): Removal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine room cover, (if equipped) using power tool. Refer to "REMOVAL AND INSTALLATION ".
Disconnect intake valve timing control position sensor connector (Bank 2) (RH).
Remove intake valve timing control position sensor (Bank 2) (RH) (1) and O-ring (2) from Intake valve timing control solenoid valve cover (Bank 1) (RH) (3).

CAUTION: Do not reuse O-ring.

Fig 1: Identifying O-ring, Intake Valve Timing Control Position Sensor (Bank 2) And Solenoid Valve Cover (RH)

Courtesy of NISSAN NORTH AMERICA, INC.