LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2222 (Engine Mechanical (VK56DE)) >> Removal And Installation >> Intake Valve Timing Control >> Intake Valve Timing Control Position Sensor (Bank 1) (LH) >> Removal

Intake Valve Timing Control Position Sensor (Bank 1) (LH): Removal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove air duct and resonator assembly. Refer to "REMOVAL AND INSTALLATION ".
  2. Disconnect intake valve timing control position sensor connector (Bank 1) (LH).
  3. Remove intake valve timing control position sensor (Bank 1) (LH) (1) and O-ring (2) from Intake valve timing control solenoid valve cover (Bank 1) (LH) (3).
    CAUTION: Do not reuse O-ring.
    Fig 1: Identifying O-ring, Intake Valve Timing Control Position Sensor And Solenoid Valve Cover (LH)
    G05378612Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals