LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2222 (Engine Mechanical (VK56DE)) >> Periodic Maintenance >> Drive Belts >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air duct and resonator assembly. Refer to "REMOVAL AND INSTALLATION ".
  2. Install Tool on drive belt auto-tensioner pulley bolt, move in the direction of arrow (loosening direction of tensioner) as shown.

    Tool number: - (J-46535) 

    Fig 1: Identifying Direction Of Tensioner
    G04899650Courtesy of NISSAN NORTH AMERICA, INC.
    WARNING: Avoid placing hand in a location where pinching may occur if the holding tool accidentally comes off.
  3. Remove the drive belt.
scientia non olet · About LEMON Manuals