LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2220 (Engine Mechanical (VQ40DE)) >> Removal And Installation >> Cylinder Head >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove camshaft. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove intake manifold. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove exhaust manifold. Refer to "REMOVAL AND INSTALLATION (EXHAUST MANIFOLD) ".
  4. Remove front final drive assembly (4WD only). Refer to "UNIT REMOVAL AND INSTALLATION ".
  5. Remove water inlet and thermostat assembly (left bank). Refer to "REMOVAL AND INSTALLATION ".
  6. Remove water outlet, water pipe and heater pipe (left bank). Refer to "REMOVAL AND INSTALLATION ".
  7. Remove cylinder head bolts in reverse order as shown using suitable tool and power tool to remove cylinder heads (right and left banks).
    Fig 1: Tightening Sequence Of Cylinder Head Bolts
    G04878414Courtesy of NISSAN NORTH AMERICA, INC.
  8. Remove cylinder head gaskets.
scientia non olet · About LEMON Manuals