Standard Brake Pedal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Do not deform the brake piping.

CAUTION:

Do not disassemble the brake pedal assembly.
Avoid damage from dropping the brake pedal assembly during handling.
Keep the brake pedal assembly away from water.

Removal

Remove the instrument lower panel LH. Refer to "REMOVAL AND INSTALLATION ".
Remove the stop lamp switch and ASCD cancel switch from the pedal assembly.
Remove snap pin and clevis pin from the clevis of the brake booster.
Remove the brake pedal assembly bolt.
Remove the brake pedal assembly nuts, then remove the pedal assembly.
- Temporarily install the nuts by hand to support the booster.

CAUTION: Do not reuse the nuts for installation.

Inspection After Removal

Check brake pedal for following items:

Cracking or deformation of clevis pin stopper (A)
Clevis pin deformation
Crack of any welded portion

Fig 1: Identifying Clevis Pin Stopper
Brake pedal bent or deformed

Installation

Installation is in the reverse order of removal.

CAUTION: Do not reuse the nuts for installation, discard and install with new lock nuts.

Check the brake pedal for smooth operation. There should be no binding or sticking when applying or releasing the brake pedal.
After installing the brake pedal assembly, adjust it as necessary. Refer to "INSPECTION AND ADJUSTMENT - STANDARD PEDAL ".