Removal and Installation: Removal
WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Be careful not to deform or bend brake piping while removing and installing brake booster.
- Replace clevis pin if it is damaged.
- Be careful not to damage brake booster stud bolt threads. If brake booster is tilted or inclined during installation, dash panel may damage the threads.
- Attach the check valve in the correct direction.
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.
- Remove the ABS actuator and electric unit (control unit). Refer to "REMOVAL AND INSTALLATION ".
- Remove the master cylinder assembly. Refer to "REMOVAL AND INSTALLATION ".
- Disconnect brake booster vacuum hose from the brake booster. Refer to "REMOVAL AND INSTALLATION ".
- Disconnect the active booster and delta stroke sensor harness connector (if equipped).
- Remove the brake pedal clevis pin (2) and snap pin (1) from inside the vehicle.
- Remove the brake booster and brake pedal assembly nuts and discard.CAUTION: Discard the nuts, do not reuse.
- Remove brake booster assembly from dash panel.