LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2120 (Roof) >> Sunroof >> Removal and Installation >> Sunroof Motor >> Removal

Sunroof Motor: Removal

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position glass lid assembly in the fully closed position.
  2. Remove roof console assembly. Refer to "HEADLINING ".
  3. Remove the sunroof motor screws (3).
  4. Disconnect sunroof motor harness connector (2), then remove sunroof motor (3).
    • ←: Vehicle front
    CAUTION:
    • When removing the sunroof motor (1), be sure that the sunroof is in the fully closed position.
    • Never run the removed sunroof motor as a single unit.
    Fig 1: Identifying Sunroof Motor, Harness Connector And Sunroof Motor Screws
    G04902894Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals