Glass Lid Assembly: Installation

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Position glass lid assembly to sunroof unit.
Install the glass lid assembly screws. (First tighten center front screw, then tighten right rear screw on glass lid assembly to prevent lid from moving while tightening remaining screws.)
After installation, perform fitting adjustment. Refer to "INSPECTION ".

Fig 1: Glass Lid Screw With Torque Specifications
Courtesy of NISSAN MOTOR CO., U.S.A.