Parking Brake Shoe: Inspection

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Visually inspect the lining for abnormal wear, damage and peeling.
Measure thickness "A" of the lining using a micrometer.
Standard lining thickness: 3.2 mm (0.126 in)

Lining wear limit "A": 1.5 mm (0.059 in)

Fig 1: Measuring Thickness Of Brake Lining

Courtesy of NISSAN MOTOR CO., U.S.A.

Visually inspect the inside of the drum for abnormal wear, damage and cracks. Measure the inside diameter of the drum using a pair of vernier calipers.

Standard inner diameter: 172.0 mm (6.77 in)

Maximum inner diameter: 173.0 mm (6.81 in)

CAUTION: If necessary, remove the parking brake shoe and check as follows.

Check the shoe sliding surface for abnormal wear and damage.
Check the anchor pin for abnormal wear and corrosion.
Check the return springs for sagging.
Check the adjuster for rough operation.