LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2117 (Parking Brake System) >> Parking Brake Shoe >> Adjustment >> Shoe Clearance

Shoe Clearance

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure the parking brake control lever is fully released and parking brake cable adjusting nut is loosened.
  2. Remove the adjuster hole plug installed on the rotor. Using a screwdriver, turn the adjuster as shown until the rotor is locked. After locking, turn the adjuster in the opposite direction 5 or 6 notches.
  3. Rotate the rotor to make sure that there is no drag. Install the adjuster hole plug.
    Fig 1: Identifying Adjuster Hole Plug
    G04916493Courtesy of NISSAN MOTOR CO., U.S.A.
  4. After adjusting the clearance of the rear shoes, adjust the parking brake cable. Refer to "ADJUSTMENT ".
    • After replacing the shoes or the brake rotor or if the parking brake does not function well, carry out the break-in procedure. Refer to "BREAKING-IN DRUM AND LINING ".
scientia non olet · About LEMON Manuals