Id Registration Without Transmitter Activation Tool

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This procedure must be done after replacement of a low tire pressure warning transmitter or BCM.

New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 before ID registration can be performed.

Connect CONSULT-III. Refer to "CONSULT-III START PROCEDURE ".
Select "AIR PRESSURE MONITOR" on "SELECT TEST ITEM" screen.
Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".

Adjust the tire pressure to the values shown in the table below for ID registration, and drive the vehicle at 15 km/h (9.4 MPH) or more for a few minutes.

Fig 1: CONSULT-III Display - SELECT DIAG MODE

Courtesy of NISSAN MOTOR CO., U.S.A.

TIRE PRESSURE SPECIFICATION

Tire position	Tire pressure kPa (kg/cm² , psi)
Front - Left	250 (2.5, 36)
Front - Right	230 (2.3, 33)
Rear - Right	210(2.1,30)
Rear - Left	190 (1.9,27)

After completing all ID registrations, press "END" to complete the procedure.

ACTIVATION TIRE POSITION

Activation tire position	CONSULT-III
Front LH	"YET" ↓ "DONE"
Front RH
Rear RH
Rear LH

Inflate all tires to proper pressure. Refer to "TIRE ".