LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2114 (Front Suspension) >> Stabilizer Bar >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire.
  2. Remove front exhaust tube using power tool. Refer to "REMOVAL AND INSTALLATION ".
  3. Disconnect the connecting rod end at the stabilizer bar using power tool.
    • Prevent the stabilizer connecting rod from turning by inserting a hex wrench into the end of the ball stud, then remove nut.
  4. Remove the rear engine mount insulator using power tool. Refer to "REMOVAL AND INSTALLATION ".
  5. Remove the LH and RH member pin stays using power tool, then remove the rear suspension member mounting nuts. Refer to "REMOVAL AND INSTALLATION ".
    • Support rear of suspension member, then lower rear of suspension member to gain access to stabilizer bar mounting brackets.
  6. Remove the two stabilizer bar brackets from the front suspension member using power tool.
  7. Remove the front stabilizer bar.
    • Remove the two stabilizer bar bushings as necessary.
    Fig 1: Identifying Strut, Connecting Rod And Stabilizer
    G04887044Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals