Removal and Installation: Installation

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

When installing stabilizer bar, make sure that the clamps are facing in the correct direction as shown.

Fig 1: Identifying Stabilizer Bar And Crimp Ring
Courtesy of NISSAN MOTOR CO., U.S.A.
Make sure that slit in bushing is in the position as shown.
Lubricate the inner and outer surfaces of the bushing using a silicone lubricant.

Fig 2: Identifying Slit And Bushing
Courtesy of NISSAN MOTOR CO., U.S.A.
Install stabilizer bar with ball joint socket properly placed as shown.
When installing wheel and tire, refer to "TIRE ROTATION ".

Fig 3: Identifying Proper Position Of Stabilizer Bar With Ball Joint Socket
Courtesy of NISSAN MOTOR CO., U.S.A.