Removal and Installation: Installation

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Tighten the two LH transaxle mounting insulator bolts to specification.
Tighten the stabilizer bar and connecting rod nuts and bolts to specification. Refer to "COMPONENTS ".
CAUTION: Tighten the suspension nuts and bolts with the vehicle on the ground.
Install the stabilizer bar bushings and brackets in the specified orientation. Refer to "REMOVAL AND INSTALLATION ".
Tighten the steering gear bolts to specification. Refer to "REMOVAL AND INSTALLATION ".
Install wheel and tire. Refer to "TIRE ROTATION ".
Check the wheel alignment. Refer to "FRONT WHEEL ALIGNMENT ".