LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2112 (Wiper, Washer & Horn) >> Front Wiper And Washer System >> Front Wiper Arms >> Wiper Arm Adjustment

Wiper Arm Adjustment

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Operate front wiper motor one full cycle, then turn "OFF" (Auto Stop).
  2. Lift the wiper blade up and then rest it onto glass surface, check the blade clearance "L1" and "L2".

    Clearance "L1": 30.5 - 45.5 mm (1.201 -1.791 in) 

    Clearance "L2": 32.5 - 47.5 mm (1.280 -1.870 in) 

    Fig 1: Adjusting Front Wiper Arm
    G04903880Courtesy of NISSAN MOTOR CO., U.S.A.
  3. If adjustment is necessary, reposition wiper arm on wiper motor pivot shaft to above specified blade clearance.
  4. Tighten wiper arm nut to specified torque, and install wiper arm covers. Refer to wiper arm installation.
scientia non olet · About LEMON Manuals