All Foot Lamps Do Not Operate

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK INTERIOR ROOM LAMP OPERATION
Check interior room lamp operation.

OK or NG

OK: GO TO 2.

NG: Inspect malfunction. Refer to "ALL INTERIOR ROOM LAMPS DO NOT OPERATE ".
CHECK FOOT LAMP POWER SUPPLY
1. Turn ignition switch OFF.
2. Disconnect foot lamp connector.
3. Open door.
4. Check voltage between foot lamp harness connector M99 (LH) or M100 (RH) terminal 1 and ground.
  1 - Ground: Battery voltage should exist.
Fig 1: Checking Voltage Between Foot Lamp Harness Connector M99 (LH) Or M100 (RH) Terminal 1 And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 3.

NG: Repair harness or connector.
CHECK FOOT LAMP CIRCUIT
1. Disconnect BCM connector.
2. Check continuity between BCM connector M20 (A) terminal 63 and foot lamp connector M99 (B) (LH) and M100 (B) (RH) terminal 2.
  63 - 2: Continuity should exist.
Fig 2: Checking Continuity Between BCM Connector M20 Terminal 63 And Foot Lamp Connector M99 (LH) And M100 (RH) Terminal 2
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Replace foot lamp.

NG: Repair harness or connector.