Rear Door Glass: Removal
WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear door finisher. Refer to "REAR DOOR ".
- Remove the inside seal.
- Temporarily reconnect the power window switch and raise/lower the door window until the glass bolts can be seen.
- Remove the glass bolts, and place the glass on the inner bottom of the panel.
- Remove the partition sash from the glass run.
- Remove the partition sash bolt (lower) and screw (upper) to remove the sash.
- Remove the glass from the inside of the panel.
- Remove the partition glass from the panel.