Power Window Serial Link Check Rear LH or RH (With Front and Rear Power Window Anti-pinch System)

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK REAR POWER WINDOW SWITCH LH OR RH
1. Replace with operative rear power window switch LH or RH.
2. Does window operates normally?
OK or NG

OK: Replace rear power window switch LH or RH. Refer to "REAR DOOR ".

NG: GO TO 2.
CHECK POWER WINDOW SERIAL LINK CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect main power window and door lock/unlock switch and rear power window switch LH or RH.
3. Check continuity between main power window and door lock/unlock switch connector D7 terminal 14 and rear power window switch connector D203 (LH) or D303 (RH) terminal 16.
  14 - 16: Continuity should exist.
Fig 1: Checking Continuity Between Main Power Window And Door Lock/Unlock Switch & Rear Power Window Switch Connectors
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Replace main power window and door lock/unlock switch. Refer to "FRONT DOOR ".

NG: Repair or replace harness.