LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2107 (Power Steering System) >> Power Steering Oil Pump >> Disassembly and Assembly >> Disassembly

Disassembly and Assembly: Disassembly

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Parts which can be disassembled are strictly limited. Never disassemble parts other than those specified.
  • Disassemble in as clean a place as possible.
  • Clean your hands before disassembly.
  • Do not use rags; use nylon cloths or paper towels.
  • Follow the procedures and cautions in this information.
  • When disassembling and reassembling, do not let foreign matter enter or contact the parts.
  1. Remove snap ring, then draw drive shaft out.
    CAUTION: Be careful not to drop drive shaft.
    Fig 1: Drawing Drive Shaft Out
    G04916620Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Remove oil seal.
    CAUTION: Be careful not to damage front housing.
    Fig 2: Removing Oil Seal
    G04876922Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Remove connector and flow control valve with spring.
    CAUTION: Be careful not to drop flow control valve.
  4. Inspect all of the power steering oil pump components, and repair or replace as necessary. Refer to "INSPECTION AFTER DISASSEMBLY ".
    Fig 3: Identifying Connector And Flow Control Valve With Spring
    G04916622Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals