LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2101 (Exterior & Interior) >> Front Bumper >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove grille top cover.
  2. Remove front grille. Refer to "FRONT GRILLE ".
  3. Remove front bumper fascia screws, then partially remove front fender protector RH/LH. Refer to "FENDER PROTECTOR ".
  4. Remove side splash cover.
  5. Remove engine undercover.
  6. Disconnect fog lamp wire harness in front bumper fascia.
  7. Remove front bumper fascia.
  8. Pull off energy absorbing foam from front bumper.
  9. Disconnect ambient temperature sensor wiring harness.
  10. Remove front bumper reinforcement.
  11. Remove front bumper supports.
  12. Disconnect wire harness and remove front combination lamp RH/LH. Refer to "COMBINATION LAMP ".
scientia non olet · About LEMON Manuals