Removal Of Liquid Gasket Sealing

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

After removing the bolts and nuts, separate the mating surface and remove the sealant using Tool.
Tool number: KV10111100 (J-37228)

CAUTION: Be careful not to damage the mating surfaces.
In areas where the cutter is difficult to use, use a plastic hammer to lightly tap (1) the cutter where the RTV Silicone Sealant is applied. Use a plastic hammer to slide the cutter (2) by tapping on the side.

Fig 1: Sliding Cutter By Tapping On Side

Courtesy of NISSAN MOTOR CO., U.S.A.

CAUTION: If for some unavoidable reason a tool such as a flat-bladed screwdriver is used, be careful not to damage the mating surfaces.