Removal and Installation for Condenser: Removal

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Discharge the refrigerant. Refer to "HFC-134A (R-134A) SERVICE PROCEDURE ".
Remove the radiator. Refer to "RADIATOR ".
CAUTION: Be careful not to damage the core surface of the condenser and the radiator.
Disconnect the high-pressure flexible hose and the high-pressure pipe from the condenser.
CAUTION: Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.
Disconnect the refrigerant pressure sensor connector.
Remove the front fascia. Refer to "FRONT BUMPER ".

Fig 1: Identifying Refrigerant Pressure Sensor Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove the mounting nuts from condenser mounting brackets.
Remove the condenser.

Fig 2: Locating Condenser Mounting Brackets Nuts
Courtesy of NISSAN MOTOR CO., U.S.A.