Removal and Installation Procedure for CVT Unit Connector: Installation

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Align CVT unit harness connector terminal body marking with bayonet ring marking, insert CVT unit harness connector, and then rotate bayonet ring clockwise.

Fig 1: Rotating Bayonet Ring
Courtesy of NISSAN MOTOR CO., U.S.A.
Rotate bayonet ring clockwise until CVT unit harness connector terminal body marking is aligned with the bayonet ring marking (linear slit) as shown

Fig 2: Identifying Bayonet Ring - Correctly Fitting Condition
Courtesy of NISSAN MOTOR CO., U.S.A.
CAUTION:
- Securely align CVT unit harness connector terminal body marking with bayonet ring marking (linear slit). Do not make a half fit condition as shown.
- Do not mistake the bayonet ring marking (linear slit) for other dent portion.
Fig 3: Identifying Bayonet Ring - Half Fit Condition
Courtesy of NISSAN MOTOR CO., U.S.A.