Removal and Installation: Installation
WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Drive the new differential side oil seal into the transaxle case side (B) and converter housing side (C) until it is flush using tool.
Tool number
Transaxle case side (B): - (J-47244)
Converter housing side (C): ST33400001 (J-47005)
Dimension A: 0 ± 0.5 (0 ± 0.020)
CAUTION:- Do not reuse differential side oil seals.
- Apply specified NISSAN CVT fluid to side oil seals.
- Install drive shaft assembly. Refer to "FRONT DRIVE SHAFT ".
- Check CVT fluid level. Refer to "CHECKING CVT FLUID ".