Step Motor

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch OFF.
Disconnect CVT unit harness connector.

Check resistance between CVT unit harness connector terminals and ground.

RESISTANCE REFERENCE CHART

Name	Connector	Terminal	Resistance (Approx.)
Step motor	F30	6 - 7	30 Ω
		8 - 9	30 Ω
		6 - Ground	15Ω
		7 - Ground
		8 - Ground
		9 - Ground

Fig 1: Checking Resistance Between CVT Unit Harness Connector Terminals And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

If NG, replace the transaxle assembly. Refer to "REMOVAL AND INSTALLATION ".