Inspection and Adjustment

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

INSPECTION AFTER REMOVAL

Check oil pan for foreign material.

If a large amount of worn material is found, clutch plate may be worn.
If iron powder is found, bearings, gears, or clutch plates may be worn.
If aluminum powder is found, bushing may be worn, or chips or burrs of aluminum casting parts may enter.

Check points where wear is found in all cases.

Check the CVT fluid level and leakage. Refer to CHECKING CVT FLUID .

INSPECTION AFTER INSTALLATION

Erase the TCM data.

Erase the CVT fluid degradation level data using CONSULT-III. Refer to CHECKING CVT FLUID .
Erase the memory of ROM using CONSULT-III.