Final Check of SRS Using CONSULT-III-Diagnosis Mode

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Refer to "CONSULT-III START PROCEDURE ".

After repairing SRS, connect both battery cables.
If no malfunction is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Go to step 3.
If any malfunction is detected on "SELF-DIAG [CURRENT]", the malfunctioning part is not repaired completely or another malfunctioning part is detected. Go to "DIAGNOSTIC PROCEDURE 2 ", and repair malfunctioning part completely.

Fig 1: CONSULT-III Function Screen Display - SELF-DIAG (CURRENT)
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "ERASE".
NOTE: Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").

If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.

Fig 2: CONSULT-III Function Screen Display - SELF-DIAG (CURRENT)
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BACK" key of CONSULT-III to "SELECT DIAG MODE" screen. Touch "SELF-DIAG [PAST]".

Fig 3: CONSULT-III Function Screen Display - SELECT DIAG MODE
Courtesy of NISSAN MOTOR CO., U.S.A.
Check that no malfunction is detected on "SELF-DIAG [PAST]".
Touch "BACK" key of CONSULT-III until "SELECT SYSTEM" appears in order to return to User mode from Diagnosis mode.
Turn ignition switch OFF then turn off and disconnect CONSULT-III.
Go to "CHECKING SRS OPERATION USING "AIR BAG" WARNING LAMP-USER MODE ".

Fig 4: CONSULT-III Function Screen Display - SELF-DIAG (PAST)
Courtesy of NISSAN MOTOR CO., U.S.A.