LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2050 (Roof) >> Sunroof >> Adjustment >> Height Difference Adjustment

Height Difference Adjustment

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

If an excessive height difference between glass lid assembly and roof panel is found, adjust in the following manner:

  1. Remove headlining. Refer to "HEADLINING ".
  2. Loosen sunroof frame assembly nuts and sunroof bracket bolts.
  3. Add shims until gap is within specification "A-A" as shown.
    NOTE: Temporarily snug nuts and bolts to prevent movement between each adjustment.
  4. Tilt glass lid assembly up and down several times to check that it moves and seals properly.
  5. Tighten sunroof frame assembly nuts and sunroof bracket bolts.
    NOTE: First tighten left front then right rear sunroof frame assembly nuts to prevent uneven torque while tightening remaining sunroof bracket bolts.
  6. Install headlining. Refer to "HEADLINING ".
scientia non olet · About LEMON Manuals