Wiper Does Not Wipe When Rear Washer Operates
WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK COMBINATION SWITCH INPUT SIGNAL
Select "BCM" on CONSULT-II. With "WIPER" data monitor, make sure "RR WASHER SW" turns ON-OFF according to operation of rear washer switch.
When rear wiper switch is in WASHER position : RR WASHER SW ON
OK or NG
OK: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".
NG: Check the wiper switch. Refer to "COMBINATION SWITCH READING FUNCTION ".