Rear Wiper Stop Position Is Incorrect

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CHECK COMBINATION SWITCH INPUT SIGNAL
Select "BCM" on CONSULT-II. With "WIPER" data monitor, make sure "RR WIPER STOP" turns ON-OFF according to wiper operation.

When wiper switch is in OFF position : RR WIPER STOP OFF

Fig 1: Identifying CONSULT II Display - DATA MONITOR

OK or NG

OK: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".

NG: GO TO 2.
CHECK REAR WIPER MOTOR CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect BCM and rear wiper motor.
3. Check continuity between BCM connector M19 terminal 44 and rear wiper motor connector D602 terminal 2.
  44 - 2 : Continuity should exist.
  
  Fig 2: Checking Continuity Between BCM Connector Terminal 44 And Rear Wiper Motor Connector Terminal 2
OK or NG

OK: GO TO 3.

NG: Repair harness or connector.
CHECK REAR WIPER MOTOR SHORT CIRCUIT
Check continuity between rear wiper motor connector D602 terminal 2 and ground.

Fig 3: Checking Continuity Between Rear Wiper Motor Connector Terminal 2 And Ground

2 - Ground : Continuity should not exist.

OK or NG

OK: GO TO 4.

NG: Repair harness or connector.
CHECK GROUND CIRCUIT
Check continuity between rear wiper motor connector D602 terminal 1 and ground.

Fig 4: Checking Continuity Between Rear Wiper Motor Harness Connector D509 Terminal 1 And Ground

1 - Ground : Continuity should exist.

OK or NG

OK: GO TO 5.

NG: Repair harness or connector.
CHECK AUTO STOP SIGNAL
1. Connect BCM.
2. Turn ignition switch ON.
3. Check voltage between rear wiper motor connector D602 terminal 2 and ground.
  2 - Ground : Battery voltage should exist.
  
  Fig 5: Checking Voltage Between Rear Wiper Motor Harness Connector D509 Terminal 2 And Ground
OK or NG

OK: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".

NG: Replace rear wiper motor. Refer to "REAR WIPER MOTOR ".