LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 2048 (Seats) >> Front Seat >> Seat Cushion Trim and Pad >> Removal

Seat Cushion Trim and Pad: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Front passenger seat is equipped with an Occupant Classification System sensor and control module. Do not disassemble front passenger seat cushion assembly or remove the trim as this will affect the Occupant Classification System calibration.
  • Always replace passenger seat cushion as an assembly.
  • When removed, the passenger seat cushion must always be placed pan side UP to prevent damage.
  • During installation, the wire harness clips must be reinstalled in the holes they were originally in.

    Do not add additional clips.

  • The Occupant Classification System control module can only be replaced as part of the seat cushion assembly.
  1. Remove the front seat assembly. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove the power seat switch knobs and power seat switch escutcheon (if equipped) (or lift knobs on manual seats)..
    Fig 1: Identifying Power Seat Switch Knob And Escutcheon
    G04903090
  3. Remove the seat cushion outer finisher.
    Fig 2: Identifying Seat Cushion Outer Finisher
    G04903091
  4. Remove the power seat switch screws.
  5. Remove four bolts and the seat cushion assembly.
    • On the fold flat passenger seat it is necessary to unclip the rear flap j-clip from the seat pan.
      Fig 3: Locating Seat Cushion Assembly
      G04903092
  6. Remove the retainer on the seat cushion frame, then remove the harness connector for the seat cushion heater (if equipped).
scientia non olet · About LEMON Manuals